enginehistory.org Forum Index enginehistory.org
Aircraft Engine Historical Society Members' Bulletin Board
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Can't see the impellor for the vanes...

 
Post new topic   Reply to topic    enginehistory.org Forum Index -> Technical Discussion
View previous topic :: View next topic  
Author Message
szielinski



Joined: 13 Jul 2003
Posts: 94
Location: Canberra, Australia

PostPosted: Sun Sep 26, 2004 17:50    Post subject: Can't see the impellor for the vanes... Reply with quote

I have looked at cutaway diagrams of centrifugal superchargers and they often seem to have rotating guide vanes in front of the impellor. My understanding is that these vanes direct air in an optimal manner onto the impellor.

Pictures of separate RGV's that I have seen have a spline inside, inferring to me that they are not mounted on a bearing but spin with the impellor shaft.

My question is this - why have two pieces ?

Why not cast an impellor extended at the inlet the same shape as the guide vanes ?
Back to top
View user's profile Send private message Send e-mail
kmccutcheon



Joined: 13 Jul 2003
Posts: 298
Location: Huntsville, Alabama USA

PostPosted: Sun Oct 03, 2004 10:32    Post subject: Reply with quote

Quote:
My question is this - why have two pieces ?

Why not cast an impellor extended at the inlet the same shape as the guide vanes ?


The rotating guide vanes (also called inducer) were made separately to ease the manufacturing process. Supercharger impellers were usually forged in order to endure the stresses of rotating at very high speeds. Parts produced by the forging process required extensive machining to produce their final shape. The complex shape of a one-piece impeller with inducer was beyond the machining technology at the time (we could now produce them with multi-axis computer-controlled machining centers) Hence, the inducer section was fabricated separately from the impeller. Ford had a patent that claimed to produce centrifugally casting impellers using permanent molds that were as strong as forged impellers and very near their final shape. It is possible that this technique could have produced one-piece impellers with inducers. So far as I know, this production method, if used at all, was only used by Ford.
_________________
Kimble D. McCutcheon
Back to top
View user's profile Send private message Visit poster's website
Display posts from previous:   
Post new topic   Reply to topic    enginehistory.org Forum Index -> Technical Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group