enginehistory.org Forum Index enginehistory.org
Aircraft Engine Historical Society Members' Bulletin Board
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Wright R-3350 exhaust placement

 
Post new topic   Reply to topic    enginehistory.org Forum Index -> Technical Discussion
View previous topic :: View next topic  
Author Message
swilkinson



Joined: 10 Apr 2010
Posts: 2

PostPosted: Sun May 02, 2010 15:19    Post subject: Wright R-3350 exhaust placement Reply with quote

Certainly the earlier R-3350s had the exhaust ports of the front row of cylinders facing forward, which complicated cooling when the cooling air hit the big collector ring in front of the engine, but was there a point at which the R-3350 changed to rearward-facing exhaust ports on the front cylinders, like the R-2800? If so, roughly when was this done? I keep seeing photos of [assumedly] later R-3350s and can't for the life of me see any forward -facing exhaust ports.
Back to top
View user's profile Send private message
kmccutcheon



Joined: 13 Jul 2003
Posts: 298
Location: Huntsville, Alabama USA

PostPosted: Sun May 02, 2010 16:12    Post subject: Re: Wright R-3350 exhaust placement Reply with quote

swilkinson wrote:
...was there a point at which the R-3350 changed to rearward-facing exhaust ports on the front cylinders


All C18A and C18BA model series engines had forward-facing exhaust ports on the front cylinders. Starting with the C18BB model series all cylinders had rear-facing exhaust ports.

The first C18BB series engines (R-3350-10) were produced in February of 1943, but production of some BA engines continued until June of 1946.

You can convert Wright model numbers into military dash numbers by visiting http://www.enginehistory.org/Wright/CWafter1930_2.pdf
There is much other information about Wright engines in that file as well.

Wright model numbers for R-3350 designated engines built after August of 1941 take the form of a three-digit specification number followed by a C18 or TC18 followed by the series designation. Prior C18 model numbers were of the form GR3350...
_________________
Kimble D. McCutcheon
Back to top
View user's profile Send private message Visit poster's website
Display posts from previous:   
Post new topic   Reply to topic    enginehistory.org Forum Index -> Technical Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group